Metal pushbutton switch product installation instructions and precautions

Metal pushbutton switch product installation instructions and precautions

(1), wire and switch or indicator light connection: connector connection mode, terminal post connection mode and pin soldering mode, according to the product type to choose.

Button connector, commonly known as connector, is a HBAN hongbo button company launched a quick disassembly, good contact performance, reliable protective terminals, beautiful shape and other major special appliances. This connection method is preferred. When using pin soldering method to connect, it should be noted: it is recommended to use a 20-30W soldering iron, the temperature is controlled at 300-330 ° C, and the soldering is completed within 2 seconds after adding flux. Avoid bad phenomena such as plastic deformation, poor switch contact, and inactive action due to poor operation.

(2) The switch and indicator light have their own dustproof and waterproof sealing rings, and the partial end has now reached the high dustproof and waterproof functions of IP65, IP67 and IP68. IP65 completely prevents dust from entering, prevents water spraying, allows small amounts of water to enter. IP67 completely prevents dust from entering, prevents strong water spraying, allows small amounts of water to enter. IP68 prevents dust from entering and prevents short-term immersion of 15mm-1mm deep water.

(3) The O-type sealing ring of the plate can be installed in any position on the inside or outside of the plate for waterproofing, as shown in the following figure: